Anti-slip Aerosols

Convenient Spray Application for Floors.
Put a light textured, barefoot grade anti-slip surface wherever you walk--interior or exterior, stairs, pool decks, ramps or walkways, concrete, ceramic, metal or wood.
Suitable for indoor and outdoor use.
Durable - finish resists peeling and cracking.
Withstands exposure to gasoline, oil and other mild substances.
Right click here and choose 'Save target as...' to download the data sheet in pdf format

Application

Preparation:

ALL SURFACES:
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a quality Cleaner/ Degreaser, commercial detergent or other suitable cleaner. Mould and mildew must be cleaned with a chlorinated cleaner or bleach solution. Rinse with fresh water and allow to dry.

STEEL:
Hand tool (SSPC-SP-2) or power tool (SSPC-SP-3) clean to remove loose rust, mill scale, and deteriorated previous coatings.

PREVIOUSLY COATED:
These must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile. Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause adverse effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator  and proper containment and cleanup.

Application:

DIRECTIONS FOR USE:
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use.
Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface.
Ensure that can is in motion when spray button is pressed to avoid runs and sags.
Apply several thin layers at a few minutes interval to achieve adequate coating thickness.
After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.

Technical:

Finish: satin
Colours: Clear, Black, Safety Yellow and White (while stocks remain).
Recommended film thickness: 25 µm dry, equals averagely 100 µm wet
Drying times: at 20°C/50% RH
To touch: 20 minutes
To handle: 60 minutes
To recoat: after 1 hour with itself
Full hardness: 7 days
Heat resistance: 100°C (dry heat), above 65°C discoloration may occur
Apply only when air and surface temperatures are between  0 - 38ºC(50 - 100ºF) and surface temperature is at least 5ºC above dew point. top